Initial support for Keysight Nem5GNR UEs, with OFDM Scan, RRC decode Support added for Keysight NemOutdoor 8.5 (ff2.41) NMFS encrypted New collections of devices and improvements Improved detection of LTE-5GNR (NSA) Technology_Mode There are updates for most technologies that Analyzer supports, with changes falling under the following This release contains support for new and updated file formats. Support added for Neighbor beam measurements Actix Analyzer Release Notes
Support added for NR_UE_Timing_Advance_Command Support updated for 12 versions of Snapdragon X55 chipset messages Improvements to MCS calculation in carrier aggregation mode NR Beamset mapping configuration tool for scanner Beam Set attributesĪdded new Neighbor cell type beam measurements Improvements to support for Samsung 5G Exynos chipset devices collected in TEMS Investigation Support for Samsung 5G Exynos chipset devices collected with XCAL
Actix layer 3 message mac#
While the Destination IP is 239.1.1.70, the Destination MAC will be the MAC of the RP, or the next-hop MAC until it reaches the RP:Īt first, no client was attempting to access the stream so the RP responded back with a PIM Register-Stop. The server switch encapsulates part of the stream into a PIM-Register and forwards it to the RP.
The server initiates the stream to the multicast address of 239.1.1.70: Note: In order for multicast traffic to traverse 元 boundaries, Multicast Routing must be enabled on the entire path between Sender and RP, and Receiver and RP, with adjacencies formed across each segment. The following topology will be used for our example: The multicast stream can now flow between sender and receiver without having to pass through the RP (source tree).
Let's start by going through a high-level overview of the expected traffic flow: